This specification was developed by representatives of member companies of the General Aviation Manufacturers Association for use in preparing Manufacturers Maintenance Data, in manual form, that will serve as a guide for the maintenance of airplanes in a continuous airworthy condition.

Measure the depth of the dent with a straightedge and feeler gauges.

A dedicated tool is necessary for the installation of the unit.

If your decision is not to replace the unit, monitor its temperature for a minimum of 15 cycles.

To make the curing process slower, decrease the heat that you apply to the compound.

Remove all loose dirt from the seat with a moist cloth.

These actuators control the movement of the ailerons and elevators, which control the flight path of the airplane.

When the autopilot disengages, an aural warning is heard from the aural warning module and the red A/P light on the autoflight status annunciator (ASA) flashes.

The backside of the title page should be left blank to avoid the need for revision and potential loss of the inserted airplane serial and registration numbers.

Except when inapplicable or inappropriate to the particular airplane model, Handbooks shall contain the recommended normal procedures for the following phases of flight, in the order shown.

The Federal Aviation Administration recognized that compliance with this specification will result in a high degree of standardization of content and format for all aircraft types.