A、 This work is applicable to horizontal installations.
B、 This work is applicable to direction installations.
C、 This work is applicable to vertical installations.
答案:C
A、 This work is applicable to horizontal installations.
B、 This work is applicable to direction installations.
C、 This work is applicable to vertical installations.
答案:C
A. 、 The manufacturers of major components must provide maintenance,
troubleshooting, inspection and repair data in the same layout of this
specification.
A. 如果通气桅杆排气量不正常,做系统测试。
B. 如果通气桅杆排气量非常多,做系统测试。
C. 如果通气桅杆排气量非常少,做系统测试。
A. ACCEPTABLE
B. ACCEPTANCE
C. ACCEPT
A. 修正空速(CAS)仅为按需使用,以符合认证机构的任何对应要求,因为飞行员
延程飞行时需按照指示空速(IAS)工作。
B. 修正空速(CAS)仅在紧急情况时使用,以符合认证机构的任何对应要求,因为
飞行员不能按照指示空速(IAS)工作。
C. 修正空速(CAS)仅在必要时使用,以符合认证机构的任何对应要求,因为飞行
员完全按照指示空速(IAS)工作。
A. 维修手册中准备某些章节的技术数据需要机身制造商和各种其它部件制造商
之间的共同贡献和密切协作。
B. 编写维修手册某些章节的技术资料时,需要机身制造商和各种其他部件制造
商之间的共同协作。
C. 机身制造商和各种其他部件制造商可以共同协作以完成维修手册,一些章节
的技术参数的编写工作。
A. To include a relocated chapter table of contents is not required if
the total chapter has been relocated, while the subsystem relocations
should then be identified in the Table of Contents at the front of the
book.
B. On conditional that the total chapter has been relocated, to include
a relocated chapter table of contents is not important,then the subsystem
relocations should then be identified in the Table of Contents at the front
of the book.
C. If the total chapter has been relocated, it is not forced to contain
a relocated chapter table of contents, and the subsystem relocations
should then be identified in the Table of Contents at the front of the
book.
A. All flow control devices within the system, such as check valves, fuel
pumps, accumulators, and relays should be included.
B. All flue control devices within the system, such as single valves, fuel
pumps, storage, and relays should be included.
C. All flow control devices within the system, such as single valves, fuel
pumps, accumulators, and relays should be included.
A. 当飞机在地面时用来估计燃油量的辅助系统.
B. 当飞机在地面时用来计算燃油量的辅助系统.
C. 当飞机在地面时用来探测燃油量的辅助系统.
A. 示意图应倾向于处理整个系统,而不是子系统,如空调系统,而不是空调系
统内的压气机或供气扇。
B. 示意图应倾向于处理整个系统,而不是附属系统,如空调系统,而不是空调
系统内的压气机或供气扇。
C. 示意图应倾向于处理整个系统,而不是附件系统,如空调系统,而不是空调
系统内的循环机或供气扇。
A. 当风速减小到 30 节以下,可以打开货舱门。
B. 当风速达到 30 节,仍然允许打开货舱门。
C. 当发动机转速减小到 30 节以下,可以打开货舱门。