Notes call attention to methods which make the job easier, or provide supplementary or explanatory information.

If the microswitch becomes unserviceable, do the deactivation procedure of the actuator to prevent damage to the valve.

If the adjustment of the stops is not correct, the results of the test will not be accurate.

Make sure that the label fully attaches to the surface and that there are no bubbles.

Apply two layers of protective compound to prevent hydraulic fluid damage to the sealant.

Refer to Table 7001 for information about how the pivot assembly is made.

While you do each step of the valve test, make sure that there is no leakage.

Remove the fuel from the ground before you try to start the engine again.

If you change this repair procedure, get approval of the design authority.

You can do this procedure only if there is no other repair in the repair area.

When you install the antenna, the alignment arrow must point forward.