Any technical data published in the ATA No. 100 format will meet the requirements of this specification although it is expected that the Paragraph 19 format will be used where no ATA-100 requirement is foreseen.

A list of corresponding serial/unit numbers (or other identifying information) is in a corresponding column on the right side of the page.

Basic control and operation information describe how the airplane components are controlled and how they operate, including any special procedures, and limitations that apply.

It is very difficult to determine the effects of corrosion but, as the reports from the CAP inspections are received, the inspection times will be adjusted for any severe problems.

Three computers collect data and parameters from the systems and put them together on the data link to the display unit.

Standardization will enhance safety through uniform interpretation of inspection requirements contained in Continuing Airworthiness Programs prepared in accord with this Specification.

The adjustment test description shall provide instructions for accomplishment of a test or check to assure the integrity as an operational component of a system, subsystem or unit assembly.

Any changes to the limitations, instrument markings, or placards of the basic Limitations (Section 2) of the Pilot＇s Operating Handbook shall be stated.

If the indications do not clearly show that a fastener is loose, make a red line across the head and the adjacent material.

Keep the elevator from moving by installing a wooden block between the inboard edge of the elevator and the tail cone.

When you do the lifting or lowering of the aircraft, make sure that the persons who operate the lifting/lowering equipment have the correct training and knowledge.