600.The manufacturer's masthead,publication title,aircraft model and
issue and revision dates or codes may be omitted from individual pages
at the option of the manufacturer in small,permanently bound manuals.

A. 　Make sure that the diameter of the hole is less than the specified value.

B. 　Make sure that the diameter of the hole is more than the specified value.

C. 　Make sure that the radius of the opening is less than the specified
value.

A. 　Adjust compass system 1 until it agrees with compass system 2.

B. 　Synchronize compass system 1 with compass system 2.

C. 　Regulation compass system 1 until it agrees with compass system 2.

A. 　导线识别代码的后缀应使用“V”字母作为后缀,以识别单相系统中未接地的
电缆或导线。

B. 　导线识别代码的前缀应使用“V”字母作为后缀,以识别单相系统中未接地的
电缆或导线。

C. 　字母“V”应用作前缀以识别导线代码和单相系统中未接地的导线或电缆。

A. 　This handbook includes the documents required to be finished to the
pilot by the federal aviation regulations and additional information
approved by the operator and contains the FAA approved airplane flight
manual.

B. 　This handbook includes the material required to be furnished to the
pilot by the federal aviation regulations and additional information
provided by the manufacturer and constitutes the FAA approved airplane
flight manual.

C. 　This aviation regulations,material provided to pilots and accurate information
provided by the manufaactures,and establishes the FAA approved airplane
flight manual.

A. 　把车拖到安全的地方,在那里可以使用标准程序。

B. 　拉动车到安全的区域,你可以使用标准过程。

C. 　把车拖到平坦的地方,在那里可以使用标准程序。

A. 　When you need to understand a schematic diagram,use arrows to indicate
flow orienting.

B. 　Arrows shall be used to indicate flow ends when needed to understand
the schematic diagram.

C. 　When need to comprehend the chart,you should use arrows point to the
direction.

A. 　ACCELERATES

B. 　AGGRAVATES

C. 　INCREASES

A. 　This material releases dangerous fumes when it touches hot surfaces.

B. 　On contact with hot surfaces, this material produces dangerous fumes.

C. 　This material happens dangerous gases when it comes into contact with
hot surfaces.

A. 　如果在测试过程中,流量指示器没有达到预定位置,则使用此备用程序。

B. 　如果在测试结束后,流量指示器没有达到设定位置,则使用此附加程序。

C. 　如果在测试结束后,流量指示器没有达到设定位置,则使用此备用程序。

A. 　设置电门每秒钟三个循环

B. 　设置电门每分钟三个循环

C. 　设置电门每三分钟三个循环