A、 Distances shown are based on weak wind.
B、 Distances shown are developed with no wind.
C、 Distances shown are on the basis of gentle wind.
答案:B
A、 Distances shown are based on weak wind.
B、 Distances shown are developed with no wind.
C、 Distances shown are on the basis of gentle wind.
答案:B
A. 如果列出了大量项目在电气示意图上,则项目应按逻辑顺序呈现,如飞机上
或示意图中项目的排列顺序。
B. 在电气示意图上,如果列出了大量项目,则项目应按逻辑顺序呈现,如飞机
上或示意图中项目的排列顺序。
C. 如果列出了大量项目,例如电气示意图上的项目应按逻辑顺序呈现,如飞机
上或示意图中项目的排列顺序。
A. The values must not be more than the approved differences.
B. The values must not exceed the allowable differences.
C. The values must not exceed the approved error.
A. 转动凸轮以使显示器松脱。
B. 转动旋钮使显示器显示消失
C. 转动把手以使显示器不在显示
A. Apply mass on the surface of the patch to ensure that the parts bond
correctly.
B. Bear down on the surface of the patch to make sure that the parts bond
correctly.
C. Apply weight on the surface of the patch to make sure that the parts
bond correctly.
A. INCREASE
B. INFLATE
C. DEFLATE
A. 从油箱内排放大约 2 升燃油。
B. 从油箱内排放至少 2 升燃油。
C. 从油箱内排放不超过 2 升燃油。
A. A value of 2 mm is permitted.
B. A value of 2 mm is rejected.
C. A value of 2 mm is unacceptable.
A. GOES
B. LEAVES
C. GETS
A. 主题标题应与本规范中使用的示例相同,或实质上等同于本规范中使用的示
例,除非因飞机型号的设计或运行特点而不适用。
B. 除了因飞机种类的设计或操作方式不适用的情况,主题标题应与本规范中使
用的示例一致或本质相似。
C. 除了因飞机类型的设计或运行方式不适用的情况,主题标题应与本规范中使
用的示例一致或近似。
A. To make the melting process faster, apply heat to the compound.
B. To make the curing process faster, apply heat to the compound.
C. To make the evaporation process faster, apply heat to the compound.