系统接口电路应能够适配连接系统的物理特性。

AIRWORTHINESS Section must set forth each mandatory replacement time, structural inspection interval, and related structural inspection procedure required for type certification.

The Maintenance Manual shall provide the location and pictorial illustrations of each placard - stencil or marking, indicating those which are required by the minimum equipment list.

The area for repair of decorative surfaces must be smaller than 100 square inches. If the area is larger than 100 in2 (645 cm2), you must replace the part.

Make sure the decorative TEDLAR laminate has the correct color and pattern. The repair will not be satisfactory if the new TEDLAR does not match the original surface.

Be careful when you open or close circuit breakers in the P91 and P92 panels while the panels have power. Electrical shock can cause injuries to personnel.

Use aluminum fitting torque values for aluminum, steel, or titanium fittings installed in aluminum bosses.

Make sure that you do not bend the rod end on the LVDT or shaft when you install the LVDT. If you bend the rod end or shaft, an incorrect indication or damage to equipment can occur.

That portion of the systems protects the control surfaces from movement by wind while the aircraft is on the ground.

They are reserved for use in those cases where the number of breakouts provided by the fourth digit in the 05-20 breakout is not sufficient to cover all of the maintenance checks dictated by subsystem 05-10 above.

In general, it is desired that the following chapter arrangements and breakdown be followed uniformly and to the maximum extent practicable in all manuals.