A、 Peel the coating from the harness.
B、 Strip the insulation from the wire.
C、 Stripe the insulation from the harness.
答案：B
A、 Peel the coating from the harness.
B、 Strip the insulation from the wire.
C、 Stripe the insulation from the harness.
答案：B
A. set the valve to fully closed position
B. set the valve to full closed position
C. set the valve to fully close position
A. 两个半圆形的挡板控制空气流
B. 两个半圆形的金属圈控制空气流
C. 两个半圆形的金属圈控制空气流
A. The engines can also use suction feed from a main tank.
B. The engines can also use suction feed from the center tank.
C. The engines can also use suction feed from the trim tank.
A. If fault message continues, push the audio cancel pushbutton on the aviation electric test panel.
B. If fault message persists, press audio cancel pushbutton on the avionics test panel.
C. If fault message goes on, press audio cancel pushbutton on the airborne test panel.
A. 将卡箱放在电缆上以将其固定到位。
B. 将线圈放在导线上以将其固定到位
C. 将线圈放在电缆上以将其固定到位。
A. The dictionary includes some unapproved words that can be technical names if you can put them in the applicable technical name category.
B. Some approved words are included in the dictionary, they can be technical names if they belong to applicable technical name category.
C. The dictionary contains some unapproved words, which can be put, in separate technical name category, they can be technical names.
A. Make an enter in the logbook to show that you did the deactivation procedure.
B. Make an entry in the logbook to show that you did the deactivation procedure.
C. Make an entrance in the logbook to show that you did the activation procedure.
A. Spoilers are used to enhance aircraft resistance in flight or to disrupt boost during landing and when take-off is canceled.
B. Spoilers are used to increase the aircraft drag in flight, or destroy the lift during landing and in case of aborted take-off.
C. Spoilers are used to increase the drag of the aircraft in flight, or to interrupt lift during landing land during rejected take-off.
A. 过热开关保护电气总管免受过热影响。
B. 过热开关保护气源总管免受过热影响。
C. 过热开关保护液压总管免受过热影响。
A. Do an inspection of fuel leakage again.
B. Do a leakage test of filter assembly again.
C. Do a leakage check of the filter assembly again.
