1208. 如果混合后超过两小时,不要使用。

2155. The ratio of width to depth must be 30 or more at each point

2154. Solvents that stay on the part can cause corrosion

2153. Extend and retract the actuator through three full cycles

2152. 在尽可能的情况下示例,相关条件和技术的说明应与图表显示在同一页上,如果页面空间放不下必要的信息则应使用面向图表的另一页面

2151. Lubricate the seal before its installation

2150. To find the middle point, divide the measured clearance by two

2149. Dents are not permitted if they prevent correct operation of the parts

2148. Use a 12-inch wrench handle during this procedure

2147. The disassembly fixture lets you disassemble the module

2146. Make sure that the rate of supply of fuel from the wing tanks to the center tank is equal