A、 If the CONTINUE is displayed during BITE test, execute the instructions presented on the CDU display before pressing LSK which is next to CONTINUE.
B、 When CONTINUE appears in the BITE test, follow the instructions shown on the CDU and then push the CONTINUE button next to LSK.
C、 If the instructions are shown the CDU display during the BITE test before you press the adjacent LSK, push CONTINUE.
答案:A
A、 If the CONTINUE is displayed during BITE test, execute the instructions presented on the CDU display before pressing LSK which is next to CONTINUE.
B、 When CONTINUE appears in the BITE test, follow the instructions shown on the CDU and then push the CONTINUE button next to LSK.
C、 If the instructions are shown the CDU display during the BITE test before you press the adjacent LSK, push CONTINUE.
答案:A
A. Adjust the clearance dimension between the extend proximity sensor[1A] and the target[1C] until the clearance dimension is out of range. Some of the ducts in the air distribution system are wrapped with compound material.
B. Adjust the clearance dimension between the extend proximity sensor[1A] and the target[1C] in case of the clearance dimension is out of tolerance. Some of the ducts in the air distribution system are wrapped with non-conductive material.
C. If the clearance dimension is not accurate,adjust the clearance dimension between the extend proximity sensor[1A] and the target[1C]. Some of the ducts in the air distribution system are wrapped with insulation material.
A. This program describes how to identify an immediate failure and how to handle a malfunction occurred.
B. This procedure explains how to recognize impending problems and what to do if malfunctions occur.
C. How to confirm the current problems and what should you do when malfunctions occur are described in this procedure.
A. Be careful when you move jet pipes or exhaust cones having insulating blankets.
B. Be careful when you move jet pipes or exhaust cones have insulating blankets.
C. Jet pipes have insulating blankets. Be careful when you move exhaust cones.
A. The SMYD 1 will limit rudder movement when flaps are up if trailing edge flaps receive data; from up limit switch of SMYD 1 during yaw damping.
B. The SMYD 1 will limit rudder movement after receiving date from up limit switch of trailing edge flaps during yaw damping when flaps are up.
C. The SMYD 1 will limit yaw camping to reduce rudder movement when flaps are up if trailing edge flaps receive data from up limit switch of SMYD 1.
A. Every time he comes under a new idea, he writes it down in his notebook.
B. Every time he thinks of a new idea, he writes it down in his notebook.
C. Every time he comes in a new idea, he writes it down in his notebook.
A. 始终保持液晶显示器在最大亮度。
B. 在液晶显示器上,最大限度保持亮度是可控的。
C. 始终保持液晶显示器的亮度处于最小状态。
A. 检查密封件是否有缺陷
B. 检查密封胶是否有
C. 检查封严是否有
A. Add 5 ml of hardener to the compound.
B. Add 5 ml of adhesive to the compound.
C. Put 5 ml of hardener to the component.
A. Pass the cablethrough the pulley
B. Pass the cablethrough the turnbuckle
C. Pass the cablethrough the quadrant
A. The aft lanyard attached to the access door to the right APU compartment is broken.
B. The after end of lanyard attached to the access door to the right APU compartment is fractured.
C. The lanyard attached to the after end of the right access door to the APU compartment is frayed.