A、 该程序应在飞机最后一次运行之后至少 2 小时完成。这将确保记录的减震支柱数值是准确的。
B、 该程序应在飞机最后一次运行后 2 小时之内完成。这将确保记录的减震支柱数值是准确的。
C、 应在飞机至少运行 2 小时,最后再完成该程序,这将确保记录的减震支柱数值是准确的
答案：A
A、 该程序应在飞机最后一次运行之后至少 2 小时完成。这将确保记录的减震支柱数值是准确的。
B、 该程序应在飞机最后一次运行后 2 小时之内完成。这将确保记录的减震支柱数值是准确的。
C、 应在飞机至少运行 2 小时,最后再完成该程序,这将确保记录的减震支柱数值是准确的
答案：A
A. ASSEMBLE
B. INSTALL
C. REMOVE
A. A word in lowercase letters is unapproved in STE.
B. A word in bold letters is unapproved in STE.
C. A word in uppercase letters is not approved in STE.
A. For release with the ground preconditioned air connection single valve inoperative in the open position,do these steps.
B. For dispatch with the ground preconditioned air connection check valve inoperative in the open position , do these steps.
C. For release with the ground recondition ed air connection check valve inoperative in the open position, do these steps.
A. The Federal Aviation Regulations require "maximum continuous power" to be used during airframe and enginecombination certification to show obedience with certain criteria.
B. Federal aviation regulations require "maximum continuing power" to be used during the certifying of the airframe andengine to meet certain criteria.
C. Federal aviation regulations， in combination of airframe and engine certification process， the use of "maximumcontinuous power"， are used to show compliance with certain standards.
A. 此章节包括了激励、传感、计算、增益、控制、作动和警告装置
B. 此章节包括了接通、感应、计算、放大、控制、作动和警告装置
C. 此章节包括了齿合、感受、计算、放大、控制、作动和警告装置
A. When hydraulic is not available, the nose landing gear can be extended by maunual and extends by airloads and its own weight;
B. When hydraulic pressure is too low, the nose landing gear can be extended by maunual and extends by airloads and its own weight;
C. The nose landing gear can be extended by maunual and retracts by airloads and its own weight when hydraulic is not available;
A. 0℃
B. 3℃
C. 5℃
D. 8℃
A. Make sure the wire in this position is able to unlock the parts.
B. The wire must be positioned so that the parts can oscillate freely.
C. Ensure the wire is positioned to create a locking motion on parts.
A. If you want to use the STE specification properly, a high professional standard is required.
B. A high level of professionalism requires the correct use of STE specifications.
C. In order to use the STE specifications appropriately, high professionalism is needed.
A. A manual for the maintenance of airplanes in a continuous airworthy condition.
B. A guide for the maintenance of airplanes in a airworthy condition.
C. A guide for the maintenance of airplanes in a continuous airworthy condition.
