A、 Find the source of the fuel leakage.
B、 Find the beginning of the fuel leak.
C、 Find the beginning of the fuel leakage.
答案：A
A、 Find the source of the fuel leakage.
B、 Find the beginning of the fuel leak.
C、 Find the beginning of the fuel leakage.
答案：A
A. Each Chapter or Section is to begin with a specific instruction of the system and its Operation and should be labeled Description and Operation"."
B. A general description of the system begins with each Chapter or Section and its operation and should be labeled Description and Operation"."
C. Each Chapter or Section is to start with a general description of the system and its operation and should be labeled Description and Operation"."
A. 滑油必须要分析。
B. 对滑油进行分析。
C. 已经分析了滑油。
A. It is urgent to establish the thorough maintenance procedure after designed and approved.
B. Once designed and approved, scheduled maintenance procedures must be built.
C. Once designed and approved, complete maintenance procedures must be set.
A. Do not replace the battery. Only an approved service provider can replace it.
B. The battery is not user-replaceable; it can only be replaced by an approved service provider.
C. Do not replace a battery without the approval from the service provider.
A. Calibrated Airspeed means the speed of an aircraft, corrected for position and instrument error. Calibrated airspeed is equal to true airspeed in standard atmosphere at sea level.
B. Calibrated Airspeed means the indicated speed of an aircraft, corrected for position and instrument error. Calibrated airspeed is equal to real airspeed in standard atmosphere at sea level.
C. Calibrated Airspeed means the indicated speed of an aircraft, corrected for position and instrument error. Calibrated airspeed is equal to true airspeed in standard atmosphere at sea level.
A. 当电表显示 28 伏特直流时,断路器闭合。
B. 当电表显示 28 伏特直流时,继电器闭合。
C. 当电表显示 28 伏特直流时,电磁阀闭合。
A. 按需补充备用灯泡集装箱。
B. 按要求补足储藏箱内的备用灯泡。
C. 按要求将灯泡装满集装箱。
A. 该部件中的空气循环使得特定部件的温度不超限。
B. 某些部件的温度不超限因此该部件中的空气能够流动。
C. 该部件中的空气的旋转和特殊部件的温度均不超限。
A. Adjust the door operating rod until it aligns with the attachment point.
B. Adjust to obtain door operating rod alignment with the attachment point.
C. Adjust the door operating rod until it get alignment with the attachment point.
A. If the filter bonds to the tool, make the tool moist with cold water.
B. If the filler bonds to the tool, make the tool moist with cool water.
C. If the filler bonds to the tool, make the tool moist with cold water.
