A、 There are three jacks onboard the fuselage.
B、 There are three jacking adapters on the fuselage.
C、 There are three jacking points on the fuselage.
答案:C
A、 There are three jacks onboard the fuselage.
B、 There are three jacking adapters on the fuselage.
C、 There are three jacking points on the fuselage.
答案:C
A. 遵守安全说明
B. 违背安全说明
C. 忽略安全说明
A. 左 1 号登机门 1 号地板右前边缘有一条 1 英寸深 6 英寸长的凹陷。
B. 左 1 号登机门 1 号地板离右前边缘 6 英寸处有一条 1 英寸深的凹槽。
C. 左 1 号登机门有一块地板到右前边缘 6 英寸处有一条 1 英寸深的凹坑。
A. When this happens, the detailed specification should indicate the permitted deviation.
B. When this occurs, the detail specification shall call out authorized deviations.
C. When this occurs, the detail suggest shall be allowed deviations.
A. N2大于10%时,不可接通起动机
B. 连续4个循环,每个不超过2分钟,每2个连续循环之间间隔20秒,4个循环完成之后,冷却15分钟后才能进行下次启动
C. 持续5分钟的循环,第1次后冷却2分钟,以后每次冷却10 分钟。
D. 持续15分钟的循环,每次冷却15分钟
A. For obtaining FAA-approved guidelines for the in-section, repairs, preservation, etc. of item influenced by STCs in ABC Manual or CAPs must be brought to the attention of the STC holder by the owner or maintenance organization.
B. Such items, effected by STCs in ABC Manuals or CAPs, must be noted to the STC holder by the owner or maintenance organization in order to acquire FAA-approved guidelined for the inspection, repair, preservation, etc. of that item.
C. The STC holder must be informed of all item affected by STCs in ABC Manuals or CAPs by the owner or maintenance organization in order to gain FAA-approved guidelines for the inspection, repair, preservation, etc. of that item.
A. 当需要了解膜片时,使用箭头指示方向。
B. 必要时应使用箭头表示流向来理解原理图。
C. 利用箭头指示的方向来理解线路施工图。
A. The test will stop when the pressure is larger than 7000 kpA.
B. Stop the test if the pressure reaches 7000 pA.
C. Stop the test when the pressure is more than 7000 kpA.
A. Seal the new sealing assemblies with 03-002 oil.
B. Lubricate the new components with 03-002 lube.
C. Lubricate the new sealing assemblies with 03-002 oil.
A. If you change this repair procedure, get approval of the Design Authority.
B. Any alteration to this repair procedure must get verbal approval of the Design Authority.
C. The Design Authority is responsible for approving and changing the repair procedure.
A. The elevators must move in an even manner.
B. The elevators must move accordingly.
C. The elevators must move correspondingly.