604.The first step should always be Job Set-up and last should be Close-Up or Clear-Up ( )

333.Do not remove dowel pins unless required in complying with Continuing Airworthiness Inspection Number 5340-04 ( )

332.Obey local regulations for the correct procedures to use or discard solvents( )

331.Make sure that the position of the clamp agrees with the position that you recorded during the removal procedure ( )

330.Make sure that the doors are closed during the pressurization test( )

329.It is the responsibility of the airplane owner and the pilot to insure that the airplane is loaded properly( )

328.To attach an item in or to a second item( )

327.IF YOU [ ]THAT THE HYDRAULIC PUMP DOES NOT OPERATE CORRECTLY , EXAMINE THE PUMP( )

326.Though techniques such as shading , crosshatching , screening or similar means are recommended, the use of color is permissible ( )

325.BE CAREFUL WHEN YOU [ ] PRINTED CIRCUIT BOARDS ( )

324.Each Chapter or Section is to start with a general description of the system and its operation and should be labeled Description and Operation ( )