Wires and wire bundles must be supported by clamps or plastic cable straps. Clamps and other primary support devices must be constructed of materials that are compatible with their installation and environment, in terms of temperature, exposure to ultraviolet (UV) light, and wire bundle mechanical loads. They should be spaced at intervals not exceeding 24 inches. Clamps on wire bundles should be selected so that they have a snug fit without pinching wires.

Left wing number 2 fuel tank access door is deformed.

Carry out permanent repair by filling damaged area with potting compound BMS-287 with reference to SRM.

When you apply hydraulic pressure, make sure that the lever does not touch the stop (1).

Different wordings are used for tightening the bolts.

The manufacturer recommends that you prepare the mixture in an area with good airflow.

For some words, there are notes that tell you to use other approved alternatives or a different construction.

The forward and aft cargo electronic units are identical.

The air goes through riser ducts and up side walls to an overhead distribution duct.

The flight compartment gets conditioned air from the left pack and the mix manifold.

A flight starts when the air mode is sensed for longer than 30 seconds.