Atmospheric conditions, including large supercooled water droplets, freezing rain or a mixture of conditions, may exceed the FAR parameters and the capabilities of the certified ice protection system.

The airspeeds which may enhance the safety of operations shall be provided as a preface to the Normal Procedures Section.

It is understood that compliance with the above can in some instances cause duplication of test procedures, which is acceptable.

The inspection/check portion shall provide information and procedure necessary to gain access to and inspection or check of a system, a unit, or an area.

AIRWORTHINESS Section must set forth each mandatory replacement time, structural inspection interval, and related structural inspection procedure required for type certification.

The Maintenance Manual shall provide the location and pictorial illustrations of each placard - stencil or marking, indicating those which are required by the minimum equipment list.

The area for repair of decorative surfaces must be smaller than 100 square inches. If the area is larger than 100 in2 (645 cm2), you must replace the part.

Make sure the decorative TEDLAR laminate has the correct color and pattern. The repair will not be satisfactory if the new TEDLAR does not match the original surface.

Be careful when you open or close circuit breakers in the P91 and P92 panels while the panels have power. Electrical shock can cause injuries to personnel.

Use aluminum fitting torque values for aluminum, steel, or titanium fittings installed in aluminum bosses.

Make sure that you do not bend the rod end on the LVDT or shaft when you install the LVDT. If you bend the rod end or shaft, an incorrect indication or damage to equipment can occur.