852、当输入杆在6毫米到8厘米之间时,测量活塞的伸长。

695 Show the date of the revision on each revised page.

694 remove the protective layer from one side of the new gasket with ANTENNA SIDE markings

693 Put the aircraft back to its initial configuration.

692 0ptional inf ormation including ( )the rationale utilized to select CAPS - how the CAP requirements were de termined

691 No part of this document may be reproduced in any form without permission in writing from the publisher.

690 Make sure that there is no dust on the surface.

689 Maintenance Practicess which are a combination of servicing,removal /installation,adjustment// test ,inspection /check,cleaning /painting,and approved repairs should follow the Troubleshooting Section.”Maintenance Practices include

688 Leave landing gear extended for ten minutes.

687 In the event a page must be added after the initial printing,use the number of preceding page with a letter suffix added for the added page( )(e.g page 1 6A,1-6B,etc).

686 If the Specification is used to prepare a Continuing Airworthiness Program for acceptance bx an airworthiness authority other than FAA the appropriate authority and its regulations may be substituted.