3.Copies of the appropriate forms and a description of the entries to be completed are available to you from an ABC dealer or Factory Customer Service Representative.

A. 　该工具用于将钢索张力调节器上的标记与固定标盘上的相关指针对齐。

B. 　该工具用于将钢索张力调节器上的标记与固定标盘上的相关刻度对齐。

C. 　该工具用于将钢索弹簧调节器上的标记与固定标盘上的相关刻度对齐。

A. 　建立单独的导线标识码,以组建追踪电路(如图5)。

B. 　建立单独的导线标识码,以协助追踪电路(如图5)。

C. 　建立单独的导线标识码,以装配追踪线圈(如图5)。

A. 　Divide the headwind component by the aircraft speed to get the correction

B. 　Divide the crosswind component by the air speed to get the correction.

C. 　Divide the crosswind component by the aircraft speed to get the correction.

A. 　In favor of reading and cross occurrence,illustrations,figures and chats should be presented in a vertical layout,if applicable.

B. 　Be convenient for reading and intercross performance illustrations,figures and diagrams should be presented in a vertical layout if pragmatic.

C. 　For ease of reading and cross reference,illustrations,figures and tables should be presented in a vertical layout,if practical.

A. 　 Material supported by the manufacturer for microfilming,including removals,shall be given on one edge only in a form suitable for photographing.

B. 　 Material required the manufacturer for microfilming,including adjustments,shall be provided on one edge only in the format of suitable for photographing.

C. 　Material supplied by the manufacturer for microfilming,including revisions,shall be provided on one side only in a form suitable for photographing.

A. 　定位器与跑道中心线对齐,下滑道与跑道出口成一定角度

B. 　航道与跑道中心线对齐,下滑道与跑道入口成恒定角度。

C. 　航道与跑道中心线平行,下滑道与跑道出口成恒定角度

A. 　当风速减小到 30 节以下,可以打开货舱门。

B. 　当风速达到 30 节,仍然允许打开货舱门。

C. 　当发动机转速减小到 30 节以下,可以打开货舱门。

A. 　包括折页和章节开头页,所有页面均盅奴面打印。

B. 　包括折页和章节开头,所有页面均应单面打印。

C. 　除了折页和章节开头页,所有页面均应双面打印。

A. 　如果在测试过程中,流量指示器没有达到预定位置,则使用此备用程序。

B. 　如果在测试结束后,流量指示器没有达到设定位置,则使用此附加程序。

C. 　如果在测试结束后,流量指示器没有达到设定位置,则使用此备用程序。

A. 　The manufacturers of major components must provide maintenance,troubleshooting,inspection and repair data in the same layout of this specification.、

B. 　Themanufacturersofmajorcomponentsislookingforwardto
maintenance,troubleshooting,inspection and repair data with the same form of this specification

C. 　The manufacturers of major components should provide maintenance,troubleshooting,inspection and repair data with same format of this specification.