A、 如果在测试过程中,流量指示器没有达到预定位置,则使用此备用程序。
B、 如果在测试结束后,流量指示器没有达到设定位置,则使用此附加程序。
C、 如果在测试结束后,流量指示器没有达到设定位置,则使用此备用程序。
答案:A
A、 如果在测试过程中,流量指示器没有达到预定位置,则使用此备用程序。
B、 如果在测试结束后,流量指示器没有达到设定位置,则使用此附加程序。
C、 如果在测试结束后,流量指示器没有达到设定位置,则使用此备用程序。
答案:A
A. Send the results of the audit to the quality department.
B. Tell the quality department about the results of the analysis.
C. Let the quality department know the results of audit.
A. 把这些部分中的每一个故障按概率的顺序列出。
B. 把这些部分按概率的顺序列在每个故障下面。
C. 把这些故障列在每个部分下面为了增加概率。
A. These tests should require no special equipment or facilities rather than that installed on the aircraft and should be comparable to the test performed by the flight crews.
B. These tests should require no special equipment or facilities other than that installed on the aircraft and should be comparable to the test performed by the flight crews.
C. These tests should require none special equipment or facilities other than that installed on the aircraft and should be comparable to the test performed by the flight crews.
A. 控力连杆组件将拉力载荷从轮轴传递到减震支柱。
B. 张力连杆组件将张力负载从轴心传递到减震支柱。
C. 扭力连杆组件能将扭力载荷从轴传递到减震支柱。
A. Do not open the entry door if the wind-speed is dangerously high.
B. Do not open the cargo door unless there is dangerous wind.
C. Do not open the cargo door if the wind-speed is dangerously high.
A. 调节螺钉转动后,使压力平稳、
B. 每次转动调节螺钉后,使压力平稳
C. 只要转动调整螺钉后,使压力稳定
A. A plasticized tab divider(when tabs are used)shall be used to mark each chapter,including the Introduction section to the manual.
B. Each Introduction section to the manual included shall be identified with a plasticized tab divider(when tabs are used).
C. A plasticized tab divider(when tabs are used)shall be marked in each chapter,including the Introduction section to the manual.
A. 当要求在页面上垂直复制插图时,插图的顶部应始终朝向纸张的左边缘。
B. 当要求在页面上水平复制插图时,插图的顶部应始终朝向纸张的左边缘。
C. 当要求在页面上垂直复制插图时,描述的顶部应始终朝向纸张的左边缘。
A. Corrosion with the chemical compound is specified m table 6001.
B. Corruption with the chemical compound is specified in table 6001.
C. Corruption with the chemical compensation is specified in table 6001.
A. If you absolutely move the lever,set the system to the neutral position again.
B. If you accidentally move the lever,set the system to the neutral position again.
C. If you accurately move the lever,set the system to the neutral position again.